Loading... Please wait...


Injection Quills

Hover over image to zoom

  • Image 1
2.00 LBS

 Product Description

High Pressure Injection Quills are used to inject chemicals pumped by metering pumps into the turbulent flow zone of high pressure water or steam lines. Available with or without check valves.

Note: Special length available for QC models only. Max length 24" all materials.



  • Spring loaded check in QC models; no check in QB models
  • High pressure to 3,000 psi
  • Available in PVC, Kynar, 316 stainless steel and Carpenter 20
  • Material of spring is HAST C for all quills


  • For lines smaller than 4" diameter, trim quill so chemical is released near center of line. Use as is for lines over 4" diameter.
  • Install with “Telltale” V-notch facing upstream so flow strikes angled face at end of quill for most rapid dispersal of injected chemical.
  • For maintenance ease, installation of an isolation valve, rated above line operating pressure, immediately b behind the quill is recommended. 

For additional information, and choosing the correct quill for your application, please review
pdf Product Cut Sheetandpdf Product Manual.

If you have any questions or need assistance in selecting the correct
tank for your application,
please don't hesitate to contact
EnviroAqua at (818) 890-3200.


 Find Similar Products by Category

 Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

You Recently Viewed...



Copyright 2019 EnviroAqua Mega Store. All Rights Reserved.
Sitemap | site by Counterintuity